|
Sujet : FCoE : retour d'expériences ; FCoE et Linux |
| gug42 |
Citation :
FCoE Initialization Protocol (FIP) snooping is an FCoE feature. In order to enforce point-to-point
links for FCoE traffic outside the regular Fibre Channel topology, Ethernet ports used in FCoE can
be automatically and dynamically configured with Access Control Lists (ACLs).
Using FIP snooping, the VFSM examines the FIP frames normally exchanged between the FCF and
ENodes to determine information about connected FCoE devices. This information is used to create
narrowly tailored ACLs that permit expected FCoE traffic to and from confirmed Fibre Channel
nodes, and deny all other undesirable FCoE or FIP traffic.
|
Citation :
When FIP Snooping is enabled on a port, the switch automatically installs the appropriate ACLs to
enforce the following rules for FCoE traffic:
Ensure that FIP frames from ENodes may only be addressed to FCFs.
Flag important FIP packets for switch processing.
Ensure no end device uses an FCF MAC address as its source.
Each FCoE port is assumed to be connected to an ENode and include ENode-specific ACLs
installed, until the port is either detected or configured to be connected to an FCF.
Ports that are configured to have FIP snooping disabled will not have any FIP or FCoE related
ACLs installed.
Prevent transmission of all FCoE frames from an ENode prior to its successful completion of
login (FLOGI) to the FCF.
After successful completion of FLOGI, ensure that the ENode uses only those FCoE source
addresses assigned to it by FCF.
After successful completion of FLOGI, ensure that all ENode FCoE source addresses originate
from or are destined to the appropriate ENode port.
After successful completion of each FLOGI, ensure that FCoE frames may only be addressed to
the FCFs that accept them.
Initially, a basic set of FCoE-related ACLs will be installed on all ports where FIP snooping is
enabled. As the switch encounters FIP frames and learns about FCFs and ENodes that are attached
or disconnect, ACLs are dynamically installed or expanded to provide appropriate security.
When an FCoE connection logs out, or times out (if ACL timeout is enabled), the related ACLs will
be automatically removed.
FCoE-related ACLs are independent of manually configured ACLs used for regular Ethernet
purposes (see “Access Control Lists” on page 93). FCoE ACLs generally have a higher prior
|
|
